Wireless Microphones; Handheld Microphone; Lavaliere Microphone; General - Optimus M50 Manual De Instalación Y Funcionamiento

5.4. Wireless microphones

5.4.1. Handheld microphone

Turn the switch to "ON" position, green led will light.
Check that RF Led lights indicating signal reception.
Set the volume using the correspondent control.

5.4.2. Lavaliere microphone

Insert the microphone into the plug of transmitter case.
Turn the switch to "ON" position, green led will light.
Check that RF Led lights indicating signal reception.
Set the volume using the correspondent controls in
transmitter case and receiver.

5.4.3. General

Low battery may produce strange noise or signal cuts.
Turn off the microphone after use to increase battery life.
If you don't want to use the microphone for a long time, please remove the batteries.
Power Led changes from green to red when low battery is detected

5.5. External inputs Mic 1/2 and Aux in

Two 6.35 mm jack microphone inputs and one RCA aux input are available. Microphone inputs
have individual volume controls. Aux input volume control is shared with embedded BGM source.

5.6. Operation of Bass and Treble

You can adjust bass and treble from its correspondent control.

5.7. Operation of digital echo

The digital effect can be used in wire or wireless microphone only; you can adjust the effect from
the correspondent control.

5.8. Audio output

This equipment has an audio output available (AUX OUT). This output can be used to send audio
to recording equipments, amplifiers or auto amplified speakers.
M50 Version 1.0
M50
Portable amplifier 50 W
Page 10 of 13