ASROCK K7NF2-RAID Manual De Usuario página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2.2
2.2
2.2 Installation of Memory Modules (DIMM)
2.2
2.2
Installation of Memory Modules (DIMM)
Installation of Memory Modules (DIMM)
Installation of Memory Modules (DIMM)
Installation of Memory Modules (DIMM)
K7NF2-RAID motherboard provides three 184-pin DDR (Double Data Rate) DIMM slots,
and supports Dual Channel Memory Technology. To enable Dual-Channel mode, you
need to install 2 DIMMs into DDR1 and DDR3 slots. Although this chipset can work on
the Dual-Channel mode with 2 different modules, we recommend users to use two
identical (the same brand, speed, size and chip-type) memory modules in the DDR
DIMM slots for optimized performance.
If you install only one memory module, please install it on DDR1 first.
If you install 2 memory modules, please install them on DDR1 and
DDR3.
Installing a DIMM
Installing a DIMM
Installing a DIMM
Installing a DIMM
Installing a DIMM
Please make sure to disconnect power supply before adding or
removing DIMMs or the system components.
Step 1.
Unlock a DIMM slot by pressing the retaining clips outward.
Step 2.
Align a DIMM on the slot such that the notch on the DIMM matches the break
on the slot.
The DIMM only fits in one correct orientation. It will cause permanent
damage to the motherboard and the DIMM if you force the DIMM into
the slot at incorrect orientation.
Step 3.
Firmly insert the DIMM into the slot until the retaining clips at both ends fully
snap back in place and the DIMM is properly seated.
8 8 8 8 8
ASRock K7NF2-RAID Motherboard

Publicidad

Tabla de contenido
loading

Tabla de contenido