Cisco Linksys NAS200 Guía De Instalación Rápida página 5

Installation
H.
Make sure your hard drives use
the SATA interface. These drives
must be formatted by the Network
Storage System. Make sure you
back up all pre-existing data before
the Network Storage System erases
and formats your hard drives. Click
Next.
I.
For physical installation, follow
these instructions:
1.
Push together the clips, and
remove the drive bay door. (If
you have only one drive, install
it in the upper bay.)
2.
Lift up the ribbon.
3.
Make sure the connector side
of the drive faces the bay, and
the label side faces up.
4.
Make sure the drive is inserted under the ribbon.
Push the drive in until it snugly fits in the bay.
5.
Replace the drive bay door.
6.
If you have a second hard drive, repeat these steps for the lower bay.
NOTE:
mirror (RAID 1) these drives, then match the drive sizes for maximum
drive use.
7.
Click Next.
6
If you install a second drive and plan to stripe (RAID 0) or
SATA Hard Drives SATA Hard Drives
Install Hard Drive Install Hard Drive