Installation; Operation - Selecta VACUO-TEMP 80047 Manual De Instrucciones

INSTRUCTIONS MANUAL
¡ATENCIÓN! IMPORTANTE PARA SU SEGURIDAD
CAUTION!!! IMPORTANT FOR YOUR SAFETY
8
4
7
J
.P. SELECTA s.a.u.
CODE 80047

INSTALLATION

Put the equipment on a flat, horizontal and level surface leaving a space
of 10 cm at the back and on each side.
For maximum efficiency, do not place the equipment in direct sunlight
or other sources of heat.
Do not use the equipment for drying or for treatment of products which
can give off gases or make explosive or inflamable mixtures.
Be sure that the voltage supply is the same as the one indicated on the
equipment features plate.
Do not use the equipment if it is NOT earthed.
If you have to change the plug, bear in mind the following:

OPERATION

1. Main switch.
2. Temperature control thermostat.
3. Vacuum gauge.
4. Ventilation valve.
5. Tempered glass bell.
6. Hotplate.
7. Nipple.
8. Silicone gasket
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.grupo-selecta.com
REV E
Blue cable:
Brown cable:
Yellow/green cable:
5
01/20211 Pag.: 10
Neutral
Phase
Earth
2
3
1
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
6