Selecta VACUO-TEMP 80047 Manual De Instrucciones página 11

MANUAL DE INSTRUCCIONES
h
b
a
d
c
J
.P. SELECTA s.a.u.
CODIGO 80047
CONTROL PANEL
a. Digital display indicating speed and time in minutes.
e
b. LED indicator for speed selection.
c. LED indicator for time selection.
d. Button for operation speed and time parameters selection.
e. Button for increasing parameter value.
f. Button for reducing parameter value.
g. Start/Stop button.
h. Overtemperatura pilot lamp indicator.
f
g
STARTING UP
1. Press the main switch (1).
2. Select the temperature led (b) to be lit with key (e). Then press key
SET (d) and keep it pressed to select temperature with buttons (e) and
(f). This will be shown in the display (a).
3. Select the time led (c) to be lit with key (f). Then press key SET (d)
and keep it pressed to select time with buttons (e) and (f). This will be
shown in the display (a).
4. Check that the gasket is adjusted and place the glass bell.
5. Open the valve (4) and connect the vacuum pump in to the nipple (7).
6. Do the vacuum, and when the vacuum gauge shows the desired
vacuum, close the valve (4).
7. Disconnect the vacuum pump from the nipple (7).
8. Press the Start key (g) in order that the equipment begins to ope-
rate with the temperature and time parameters already changed.
Temperature (b) or time (c) led will begin blinking, which means
that the equipment is warming up. The temperature will increase
till reaching the programmed temperature. Once reached, the time
programmed begins to discount. When the time arrives to zero, the
led will remain fixed on and the machine will stop warming up.
9. When it is necessary to remove the glass bell, open the valve (4).
Nota: If the material inside the glass bell can produce gases that can
damage the membrane of the vacuum pump, it is recommended to
place a water jet pump between the vacuum pump and the Vacuo-temp.
CAUTION! Serious burns can be produced, with the hotplate surface,
even after switching off the equipment.
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.grupo-selecta.com
REV E
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
01/2021 Pag.: 11