Blaupunkt GT4000 Manual Del Usuario página 14

SYMBOLS
Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper interpretation of these
symbols will allow you to operate the tool more safely and effectively.
V
–
n
o
OPERATIONS
A. Pack contents 1 x Line Trimmer 1 x Safety Guard
1 x Cross Head Screw M4x25 (for fitting guard)
1 x Spool & Line (fitted)
1 x Edging wheel bracket with edging wheel
4 x Screws ST4.2x15 (for fitting the handle & safety guard )
1 x Auxiliary Handle
1 x Instruction Manual
B. Replacing the spool kits.
1. Disconnect the mains plug.
2. Press together the both locking devices at the spool cover and remove the latter.
3. Remove the thread spool kits from the spool cover. 4.Remove dirt and grass residues.
5. Thread the both cutting line ends of the new spool kits through the holes of the impeller. (each one end through one hole) .
6. Firmly place the spool kits in the spool cover. Make sure that the cutting line are not caught and pull them approx. 9 cm out of
the spool.
7. Place the spool cover with spool kits on the impeller and press it firmly down until the locking devices of spool cover securely
click into place.
C. Connect the Safety guard and wheel bracket rst.
1. Align the edging wheel bracket (12) with the safety guard (11);
2. Secure the edging wheel bracket and the safety guard with three screws supplied.
3. Align the spigot of the edging wheel brace-guard assembly with the notch at the motor housing and
place the bracket guard assembly on the trimmer head.
Volts
Alternating current
No load speed
Double insulated
Warning
Wear eye protection
Wear hearing protection
Disconnect and discontinue use should the power-cord be damaged
Hz
Hertz
W
Watts
/min Revolutions or reciprocation per minute
Regluator compliance mark
5124
Read instruction manual
Do not operate in the rain
Keep bystanders away