11. Trouble shotting
Zero setting error (Image 7)
Out of calibration range.
Action:
-Make sure you are using the correct calibration solution, referred on the specification table.
-Make sure there is sufficient amount of calibration liquid to cover the prism surface.
Measurement Error
Exceeds the specified measurement range (Image 8)
The reading is below the specified measurement range (Image 9)
Not enough liquid on the prism (Image 10)
Image 8
Temperature error
Temperature exceed range (Image 11)
Action:
-Check temperatures of sample liquid, device and ambience.
Temperature under range (Image 12)
Action:
-Check temperatures of sample liquid, device and ambience.
Image 7
Image 9
8
Image 10