Emptying The Dirty Water Tank - RugDoctor FlexClean FCM-1 Manual Del Usuario

Maintenance and Care:

EMPTYING THE DIRTY WATER TANK

IMPORTANT
:
Empty the DIRTY WATER TANK before the dirty water reaches the "FULL LINE."
1
Turn The
Machine Off
Press the POWER
SWITCH to the "OFF"
position.
3
Remove The
Dirty Water Tank
Remove the DIRTY
WATER TANK by
grasping the TANK
HANDLE and lifting
straight up.
5
Secure The Dirty
Water Tank
Place the DIRTY
WATER TANK back
onto the machine by
setting it straight
down on the base.
r u g d o c t o r . c o m | 1 - 8 0 0 - 7 8 4 - 3 6 2 8
2
Unplug The
Power Cord
Unplug the POWER
CORD from the outlet
and wrap it around the
POWER CORD WRAP.
4
Empty The Dirty Water
Unscrew the DIRTY WATER CAP
counter-clockwise and set aside.
Pour out the dirty water.
Rinse out the DIRTY WATER TANK
thoroughly with warm water.
Replace DIRTY WATER CAP.
NOTE: DO NOT pour into sink or
tub. Dirty water should be poured
into toilet or outside.
6
For A Deeper Clean
To clean the DIRTY WATER TANK more thoroughly:
1. Turn the DIRTY WATER TANK upside down to
locate the FLOAT CAP.
2. Unscrew the FLOAT CAP turning
counterclockwise.
3. Remove the FLOAT ASSEMBLY. Clean inside the
tank with a towel or a cleaning brush.
4. Replace the FLOAT ASSEMBLY. Firmly tighten the
DIRTY WATER CAP by turning clockwise until
tightened.
15