Dr. Schandelmeier MediSafe Dreamer+ Manual De Instrucciones página 11

installing the car seat with a 3- point safety belt
When installing the car seat follow the installation instructions for the 3-point safety belt
described above (under section the seat belt). A 3-point safety belt is shown in
Place the baby car seat in the sleeping position
this is the installation of group i and it is for the children whose weight between 9-18 kg
Place the baby car seat in the sleeping position on the car seat (see
joint shaft. Take the joint shaft out of the seat.
C1
safety belt through the seat back from the middle of top and fixed it into the buckle on the car
seat. The seat will be fixed by two belt in two directions. One belt from the top of the seat and the
other is in horizontal position.
belt & shoulder belt), use lock-off device to clip it. So it can not move.
to its original position and fix seat back by its metal shaft and lock the shaft safety.
this is the installation of group ii and it is fit for children whose weight between 15-25 kg
After the installation, please take away the belt system of baby car seat (including belt pads,
shoulder belt, buckle & crotch strap jacket).
the hook and then through the hole in the corner of the bottom.
the hole, insert it into the buckle.
Placing your child in the car seat
Loosen the shoulder belts by pressing the release button and pulling the shoulder belts towards
you. Note! Do not pull on the belt pads. Open the belt buckle.
E1
shell. Put your child comfortably with his/her back against the shell and make sure that there
E3
are no toys or other hard objects in the shell. Slide buckle tongue sections together and insert
them in the buckle.
system & pull the belts tight by the adjuster belt.
note!
1. The tighter the belts are around the child, the better the protection.
2. Check that the textured side of the belt pads is on the shoulders of your child
3. The belts should never be twisted.
4. If you are unable to click the tongue sections in the buckle, unblock the buckle by pressing the
red button and try again.
5. If you are not able to fasten the harness belt properly or pull it tight, contact your supplier
immediately. Under no circumstances use the product!
Locked by the buckle of the car belt.
C4
D3
E
Pull the shoulder belts tight.
E4
B
on the car seat.
A
Then pull the seat back.
C2
Put your kid into the baby car seat, car belt pass
D1
Pull the remaining slack out of the belt
E5
E6
– 11 –
.
B
) hold the handle of the
A
Install the
C3
Tighten car belt (knee
C5
Put the seat baby back
C6
C7
After the car belt through
D2
Draw the belts over on the
E2
C
D