Dr. Schandelmeier MediSafe Dreamer+ Manual De Instrucciones página 12

instruction manual for child safety seat „Dreamer" and „Dreamer+"
GB
group 1 + 2 : for children from 9-25 kg
adjusting the height of the shoulder belts
The correct belt height of the shoulder belts is attained when the belt disappears into the shell
slightly above the shoulder belts fit properly over the shoulders of the child
belts by pressing the release button and pulling the shoulder belts towards you as far as possible.
note! Do not pull the belt pads. Place the baby car seat in the sleeping position
guard door. Remove the shoulder belts from the belt yoke .
F1
the shell and the cover out of the belt pads, but make sure that the buckle remains fixed to prevent
the belts twisting.
F3
tion, place the baby car seat in the sleeping position
the third position, place the baby car seat in the sitting position
on the shoulder pads at the back of the seat.
height slots. Make sure the shoulder pads are not twisted, then tie the nylon fasteners tape.
F5
Thread the shoulder belts through the adjusted belt pads, the cover, sponge cushion and shell
Refit the shoulder belts to the belt yoke and check that the red stitching on the belts ends and the
belt yoke are facing the shell
door. Fasten the cover all around, fix with pins. check that it works!
removing the cover and the belt pads
Loosen the belts and the belt pads, see
screwdriver, and take away the lap belt guide on the cover.
the release button/positioning handle
the cover. Then remove the cover by pulling it carefully behind the release mechanism
the buckle and buckle sections back through the cover and fasten the cover at the release button/
positioning handle.
through the belt pads, the cover and the shell
sure that the red stitching on the belt ends and the belt yoke are facing the shell,
case, your belts are twisted, fasten the cover all around, behind the pins
checklist & Warranty
checklist
For safetys sake read through this checklist before you set off. Check that the harness belt system
If you wish to alter the belts from or to the lowest position or the highest posi-
if this is not the case your belts are twisted, then close the belt guard
F8
. Pull the belts, buckle tongue sections and buckle through
G2
Secure the cover on pins
G3
F
. If you wish to alter the belts to the second or
A
Thread the shoulder pads through the appropriate
F4
G
to . Unscrew the back of the lap belt guide with
F1 F4
Loosen the cover all around and also at
G1
. Close the buckle
G4
. Attach the shoulder belts to the belt yoke and make
F7
– 12 –
Loosen the shoulder
E7
and open the belt
A
Pull the shoulder belts through
F2
. Untie the nylon fasteners tape
A
and thread the belts
E4
if this is not the
F8
. check that it works!
G5
E1
F6
.
F7
. Thread
G3