Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CHANNEL CONtROL
Configuring the Channel Menu
¦
Antenna → Air / STD / HRC / IRC
❑
Before your television can begin memorizing the available channels, you must specify the type
of signal source that is connected to the TV (i.e. an Air or a Cable system).
STD, HRC and IRC identify various types of cable TV systems. Contact your local cable
N
company to identify the type of cable system that exists in your particular area. At this
point, the signal source has been selected.
Auto Program
❑
First, select the correct signal source (Air, StD, HRC, or IRC).
The TV automatically cycles through all of the available channels and stores them in memory. This takes about one to two
N
minutes.
Press the ENtERE button at any time to interrupt the memorization process and return to the Channel menu.
N
To stop the search before it has finished, press the ENtERE button with Stop selected.
N
Channel List
❑
For detailed procedures on using the Channel List, refer to the 'Managing Channels' instructions.(refer to page 15)
You can select these options by simply pressing the CH LISt button on the remote control.
O
fine tune
❑
Use fine tuning to manually adjust a particular channel for optimal reception.
If you do not store the fine-tuned channel in memory, adjustments are not saved.
N
* will appear next to the name of fine-tuned channels.
N
To reset the fine tuning setting, press the ▼ button to select Reset, then press the ENtERE button.
N
Color System →
❑
Auto
Normally the TV can receive image and sound with good quality when in the mode auto. This mode detects the signal color system
automatically. In case of some signal reception with color unsatisfactory, select the Color System Mode to PAL-M, PAL-N or NtSC.
/
/
/
PAL-M
PAL-N
NtSC
English -
tV
Channel
Antenna
: Air
Picture
Auto Program
Channel List
Sound
fine tune
Color System
: Auto
Channel
Setup
Input
UMove
EEnter
RReturn
Publicidad
Capítulos
Tabla de contenido
