Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
2. Assemble outer handle (E) by inserting the
male end of each outer handle (E) section into
the corresponding female end in order to make a
complete ring.
3. Place firebowl (F) on its side on a smooth,
clean surface. Attach one air vent (D) by
inserting two M6x12mm bolts (CC) through
pre-drilled holes in firebowl (F) and air vents (D)
as illustrated. Repeat with remaining air vents (D)
Tighten all bolts with a screwdriver.
Hardware Used
M6x12mm Bolt
CC
4. Attach Leg (G) to the firebowl (F) by inserting
M6x15mm bolts (AA) through pre-drilled holes in
firebowl (F) and leg (G) as illustrated. Tighten all
bolts with wrench (EE).
Hardware Used
M6x15mm Bolt
AA
EE
M6 Wrench
2
3
x 6
D
4
x 8
x 1
5
E
F
F
AA
G
CC
Publicidad
Tabla de contenido
