Publicidad
Idiomas disponibles
Idiomas disponibles
bEFoRE fitting the ankle positioners to any wheelchair/seating system, please consult
the wheelchair/seating system manufacturer's manual (or contact them) to find out if it is
acceptable to do so.
ankle Positioner assembly
1.
Place the user's foot or shoe on the footplate and set the webbing bridge clear of
the foot (Fig. 1), in line with the ankle bone. Mark the holes to be drilled.
2.
Drill 4 holes in each foot plate to suit either assembly method (Fig. 2 & Fig. 3).
3.
Attach the webbing bridge with the provided hardware.
4.
Insert the three-bar slide on the ankle holder strap and thread the strap under the
webbing bridge and back into the slide (Fig. 5). Note: Do not tighten the strap at
this point.
October 2016
EN - aSSEmblY iNStRUctioNS
Figure 1
Use suitable
drill for self
tapping screw
Figure 3
4
Use 3/16" drill
for nut & bolt
hardware
Figure 2
Figure 4
Figure 5
Publicidad
