Publicidad
Idiomas disponibles
Idiomas disponibles
ankle Positioner adjustment
5.
Place the positioner above the ankle, aligning the outer pads with the ankle bones
and the rear of the positioner just above the heel, then feed the strap through the
buckle (Fig. 6).
6.
Pull the strap through the buckle until a tight/comfortable fit is achieved (Fig. 7).
Press the hook and loop together.
7.
Hold onto the three-bar slide and pull the strap tight until the positioner holds the
foot firmly to the footplate (Fig. 8). Thread the strap back through the three-bar slide
(Fig. 9).
8.
Follow the above steps for the other positioner.
9.
To release the positioner, follow the above steps in reverse. Do Not adjust the
webbing bridge straps unless you wish to alter position.
Poziform
EN - aSSEmblY iNStRUctioNS
Figure 6
Figure 8
5
Figure 7
Figure 9
Publicidad
