CASATELLI WENDY Generalidades - Advertencias - Instalación - Mantenimiento página 28

6.7 RELOADING THE FUEL
To load fuel inside the machine while it is running, follow
the procedure below:
• Open the fire door slowly to prevent the creation of
an air gap inside the fireplace that would cause the
smoke to escape in the environment (based on the
draught of the fume exhaust duct).
• Reload the fireplace with fuel and then close the
fire door.
Avoid overheating the stove by loading an excessive
amount of fuel.
Insert the fuel only when the grill bases are formed
and the flame is low.
6.8 ADJUSTING THE PRIMARY AIR
Primary combustion by placing air in the fire box. This is
regulated by the register located on the front of the ash
box door (-6.4-).
If you want to get a quicker combustion, pull the air
register outwards to open the valve.
If you want to achieve a slower combustion, push the air
register inwards to partially open the airflow.
When lighting for the first time of the day or if the wood
is damp, it is advisable to keep the register fully open.
Once the fire is burning it is advisable to adjust the air
register depending on how much heat is required or how
long you want the load of firewood to last. When the fire
has been lighted up, the stove can work at the nominal
charge and the combustion air register can be turned off..
The draught should be adjusted by the installer at stove
commissioning.
If the fume exhaust duct draught is optimal, leave the
valve open, if the draught is excessive close it making
sure that there are no smoke puffs in the environment if
the door is opened.
The declared nominal yield of the chimney is obtained
by burning the right quantity of wood, making sure not
to overload the combustion chamber. The ideal length of
the wood is provided by the length of the log holder.
28
28
00 477 6240 - 09/2017 - PN - Italy
+
fig. 6.4
LIBRETTO PRODOTTO - cod. 004776860 - 13/03/2019
-