Playing Tracks In Random Order; Shuffle Play; Playing Tracks Repeatedly; Repeat Play - Sony CDX-525RF Manual De Instrucciones

Ocultar thumbs Ver también para CDX-525RF:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Locating a specific disc
— Disc Select
During playback, press (DISC+) or
(DISC–) once for each disc you wish to
skip.
To locate succeeding discs
DISC
To locate previous discs
DISC
R
Stopping CD play
Press (OFF).
Notes
• When CD playback is stopped, you may hear some noise
from the speakers. To prevent this from happening, turn
the volume down before stopping CD playback.
• If you turn off the ignition switch of your car without
stopping CD playback, it will automatically resume CD
playback from where it was stopped when you turn on
the ignition switch again.
Listening to the radio or a tape
Be sure to stop CD playback before you start
listening to the radio or a tape.
Note
Be sure to stop CD playback, otherwise there may be some
interference with radio reception.
Playing tracks in random
order

— Shuffle Play

You can select:
• SHUF 1 to play the tracks on the current disc
in random order.
• SHUF 2 to play all the discs in random
order.
Press (SHUFFLE) or (SHUF) repeatedly
until the desired setting appears (SHUF 1
or SHUF 2).
z SHUF 1
z SHUF 2
Shuffle play starts.
To go back to the normal playback mode, press
(SHUF) until "SHUF" disappears.
z Cancel (SHUF off)

Playing tracks repeatedly

— Repeat Play

You can select:
• REP 1 to repeat the track.
• REP 2 to repeat the disc.
Press (REPEAT) or (REP) repeatedly until
the desired setting appears (REP 1 or REP
2).
z REP 1
z REP 2
Repeat play starts.
To go back to the normal playback mode, press
(REP) until "REP" disappears.

Changing the output level

You can select the output level from the CD
changer. Normally the system is used in the
initial output level; change the level if
necessary.
1
Press (REP) for two seconds.
2
Press (REP) momentarily.
00 0
3
CD
LEVEL
Initial setting
3
Press either the left or right side of
(AMS) to select the output level.
To decrease the output level
0
=:
1
CD
LEVEL
To increase the output level
00 00
+:
4
CD
LEVEL
4
Press (REP) for two seconds.
z Cancel (REP off)
GB
7

Publicidad

Tabla de contenido
loading

Tabla de contenido