Domus DTA-45 Manual De Uso Y Mantenimiento página 74

7- Regulate the gas inlet screw (C) until the required pressure is reached according to the
table on page 16. Do not over-tighten the Nylon bolt as there is a risk of breaking the
internal spring and causing fuel leaks.
8- Put the cover (C) of the electro valve back on.
9- Remove the tube from the pressure gauge.
10- Fasten the screw (B).
-When the machine has been modified to work with a different type of gas to that
specified, put the corresponding new name plate and yellow label on it, which is
inside the plastic bag of the new injectors.
PRESSURE
REGULATOR SCREW
73