Domus DTA-45 Manual De Uso Y Mantenimiento página 82

4.4. Key associated functions
When the different buttons are pressed, the functions described modify the machine
conditions.
Button Machine status
Select Programme selection
Temperature selection
Time selection
Programme selection
While operating.
Temperature selection
While operating.
Time selection
In case of alarm
Arrows Programme selection
Temperature selection
Time selection
Start/Stop Programme selection
Time selection
Temperature selection
Operating
In case of alarm
Prog. (x3) Machine stopped
4.5. Information displayed
The display offers different types of information, including the programme number, the time
remaining and the temperature setting. The information may vary according to the state of
the machine at any moment.
When the machine is operating, the clock symbol flashes.
When the heating is ON, an arrow pointing upwards appears next to the thermometer.
The following table shows all the possible information displays and the conditions in which
they are displayed.
Display Machine status
MP In the ignition (2s)
END End / Anti-crease
AL-X Alarm
(2) The End / Anti-crease cycle lasts a maximum of 99 minutes. During this period, an alarm
will sound every three minutes, reminding you that the cycle has finished. After 99 minutes
the machine returns to the status: Pause.
.
Display
P01 Switches to temperature selection
60º Switches to time selection
25'
Switches to programme selection
P01 Switches to temperature selection
60º Switches to time selection
25'
Switches to programme selection
AL-X Reset alarm
P01 Increase / Decrease Programme No.
60º Increase / Decrease temperature
25'
Increase / Decrease time
P01 Start the cycle with the last selected parameters
25'
Start the cycle with the last selected parameters
60º Start the cycle with the last selected parameters
For the selected programme
AL-X Reset alarm
Enters programming mode
Comments
Shows software version
End of cycle / anti-crease cycle
Displays one of the alarms, see section 5
Action
(2)
81