Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Connection Guide
1.
Connect the camera's DC and BNC cables to the extension cable, twist the BNC
connector to lock it together securely.
2.
(Optional) If you intend to use the OSD controller, connect the camera's green RS485
plug to the extension cable. You may first need to attach the RS485 plug to the wires
on the cables as shown in the diagram above.
3.
Connect the the other end of the BNC extension cable to an unused channel on the
back of your DVR and twist the connector to lock it on securely.
4.
Connect the extension cable's DC socket to one end of the power splitter cable.
5.
(Optional) To use the OSD controller, plug the extension cable's RS485 plug (note red
connector to A/+ and black connector to B/- on the controller socket) and the other end
of the power splitter to the OSD controller's RS485 port and DC in power jack.
6.
Connect the power splitter cable to the power adapter, and plug the power adapter into
a wall outlet.
Note: Once the camera is set up and working well it is a good idea to wrap some electrical
tape around the connections between the camera cable and the BNC extension cable
to keep moisture out and preserve the electrical integrity of the connection.
4
2
1
6
4
5
3
Publicidad
Tabla de contenido
