habitat et jardin Relax 1 1351 Serie Manual Del Usario página 9

LIGHTING PROCEDURE
1. Turn the control knob to
"OFF" position.
2. Turn LP cylinder gas valve to
fully open position.
3. Push in gas control knob and
turn counter-clockwise to
"LOW" position, this will light the burner. If
needed, keep depressing and turning control
knob counter-clockwise until the burner lights.
(You will hear 1 clicking noise).
4. Once the burner is lit, continue to keep the
control knob depressed for at least 30
seconds, Then release control knob.
5. If burner does not stay lit, repeat steps 3 and
4 after 5 minutes.
6. If burner still does not stay lit, then:
a) Push in gas control knob and turn counter
clockwise to the "LOW" position.
b) keep depressing the control knob, put long
stem lighter into the ignition hole on the
emitter screen to light the burner.
c) Repeat step 4.
7. Turn the control knob counter clockwise to
"HIGH" position. If you want a lower
temperature, turn the control knob clockwise
to the "LOW" position
These lighting instructions must be
followed. An unsafe condition can
occur if they are not followed correctly.
Flame Characteristic
The flame pattern at the emitter screen
should be visually checked whenever heater
is operated.
Normally the burner flame is blue, but little
yellow flame is acceptable.
If flames extend beyond surface of the emitter
grid, or the phenomena of flame lift or light back,
or black spot is accumulating on the emitter
grid or reflector, the heater should be turned
off immediately. The heater should not be
operated again until the unit is serviced and
or repaired.
9