Final Assembly; Battery Connection; Wiring Diagram - Quantum ELM2L Manual De Instrucciones

FINAL ASSEMBLY

Connect the polarized battery plug to
4
the charger board. Make certain that
the battery cable is routed to avoid
interference with the AC input
connector or other components.

Battery Connection

Note: some details may vary
battery connector
Battery Type Total Load
NiCd
LiFePO4 (LTP)
INSTALLATION and WIRING (CONTINUED)
5

WIRING DIAGRAM

Input from branch circuit. See label on
wire pair for voltage requirement.
2.4W
4.8W
Status Indicator LED
Housing attachment to mounting plate:
Make certain all wires and connectors are
routed to avoid interference with other
components. Align latch openings on
underside of housing with latch buttons
on mounting plate. Firmly push housing
straight onto mounting plate, making
certain all four latches are fully engaged,
and the housing is closely aligned to the
mounting surface.
DC output to the remote units. See label on wire
pair for positive and negative polarity colors
Battery
Remote test Option
(standard with SDRT)
Federal Communications
Commission (FCC) Requirements:
This device complies with Part 15 of
the FCC Rules. This device may not
cause harmful interference.
Lamp
Lamp
Test Switch
page 3