Final Assembly; Wiring Diagram; Top View - Quantum ELM4L Manual De Instrucciones

FINAL ASSEMBLY

Connect the polarized battery plug to
4
the charger board. Make certain that
the battery cable is routed to avoid
interference with the AC input
connector or other components.
Battery Connection
Note: some details may vary
battery connector
Input Pin
Wire color
Voltage No.
1 White
120V-
347V
Black or
3 Orange
Yellow or
2 Red stripe
5V-30V
Blue or
4 Black stripe
Status Indicator LED
Battery Type
NiCd
LiFePO4 (LTP)
LiFePO4 (LTP HO)
LiFePO4 (LTP EHO)
INSTALLATION and WIRING (CONTINUED)
5

WIRING DIAGRAM

Input from branch circuit. See label on
wire pair for voltage requirement.
PIN 1
PIN 3
Battery
Wire Label
Type
NiCd
HOT
120V-347V
LTP
Only
Total Load
6.6W
11.0W
22.0W
33.0W
Housing attachment to mounting plate:
Make certain all wires and connectors are
routed to avoid interference with other
components. Align latch openings on
underside of housing with latch buttons
on mounting plate. Firmly push housing
straight onto mounting plate, making
certain all four latches are fully engaged,
and the housing is closely aligned to the
mounting surface.
DC output to the remote units.
Yellow/Red stripe (+)
Battery
Antenna
Test Switch
Remote test Option
(standard with SDRT)
Federal Communications
Commission (FCC) Requirements:
This device complies with FCC Title
47, Part 15, Subpart B. This device
may not cause harmful interference.
Blue/Black stripe (-)
PIN 2

Top view

PIN 4
Lamp
Lamp
AELR
Module
page 3
Antenna