Alarm Setting - BEARWARE 302658/20161220FZ004 Manual De Instrucciones

6.2 Alarm setting

Press the "alarm" button in time mode to activate the alarm. The alarm symbol
appears on the display once the alarm is activated.
Press and hold the "Alarm" button for 2 seconds to access the alarm settings.
The settings can be adjusted using the "UP" and "DOWN" buttons. Confirm the
respective setting using the "Alarm" button. The setting sequence is as follows:
Hour - Minute
The alarm symbol on the display starts flashing once the audible alarm is heard.
The audible alarm has several levels:
0-10 seconds alarm: 1 beep
10-20 seconds alarm: 2 beeps
20-30 seconds alarm: 3 beeps
30 seconds - 2 minutes alarm: continuous beep
If the alarm is not turned off within 2 minutes, it switches off automatically.
Press the "Snooze/light" button during the alarm to activate the Snooze mode
and to temporarily turn off the alarm. The alarm is turned off for about 5 minutes
and then goes off again. A snooze symbol appears on the display when the snooze
mode is active.
Press any button (except the "Snooze/light" button) to turn off the alarm. The
alarm will be enabled again on the next day at the configured time, unless you
turn off the alarm using the "Alarm" button and the alarm symbol is no longer
shown in the display.
6.3 Radio signal
Press the "wave"button to enable or disable the radio search mode. The radio
symbol appears on the display when the search mode is enabled.
The radio alarm clock searches for a signal every day at 1:00, 2:00, 3:00, 4:00 and
5:00 a.m.
Once the daylight saving time (DST) is received, a "DST" symbol appears in the
display.
11
English