Janome Quilting Kit Manual Del Usario página 3

Convertible Free Motion Quilting Foot (QB-S) Set
For a more pleasurable free-motion quilting experience, this set includes 3 left needle position feet and
1 zigzag stitch foot (center needle position).
Contents
q Closed foot
w Open foot
e Clear view foot (L)
r Clear view foot (M)
Attaching the foot
Remove the foot holder and attach the free motion quilting foot. Make sure
that the needle enters the hole in the foot.
Changing the sole
Raise the foot and turn the round nut (A) to bring the sole to the lowest
position.
Remove the setscrew (B) and remove the sole.
Attach the desired sole and secure it with the setscrew.
NOTE:
The clear view sole (M) can be used for zigzag stitches and straight stitch
with center needle position.
All other soles must be used only for straight stitch with left needle position.
Adjusting height of the foot
Lower the foot (turn the handwheel to bring the presser bar to the lowest
position on the embroidery machine).
Adjust the height of the foot by turning the round nut (A) until
the bottom of the foot barely touches top of quilt layers.
Machine Settings
Stitch:
Straight stitch (left needle position)
Thread tension: Auto
Feed dog: Lowered
Sewing
Sew at medium speed while guiding the quilt layers with your hands.
Move the quilt layers 3 mm or less per stitch.
CAUTION:
Do not move or pull the quilt layers toward you when sewing with the open sole
foot, otherwise the needle can warp and may hit the needle plate to break.
NOTES:
Use the straight stitch needle plate when sewing with straight stiches.
Increase the thread tension to 4-6 when sewing straight stitch with center needle position.
Sewing with zigzag stitches:
Set the stitch width at 7 or less.
Use purple tip needle to prevent slip stiches.
q w
3
e r
(B)
(A)
(A)