Safety Instructions; Technical Data; Before Use - Metal Works CAT2TLL Manual De Instrucciones

Safety instructions

• Please read these instructions BEFORE using the jack.
• Always ensure that other personnel are well clear of the load being lifted.
• This jack has been designed for using in the elevation of cars and lorries.
• The jack should be placed on solid level ground.
• Always block or chock wheels and apply the vehicle hand brake.
• Use additional safety support devices (such as axles stands (754753030(3 T) -754756060 (6 T) 754751212 (12 T))
to support the vehicle before accessing underneath the vehicle.
• Do not load the jack beyond it's rated capacity.
• Always check that the jack is in good working order before use.

Technical data

Model
Capacity
Minimum height
Maximum height
Lifting height
Weight
Spare parts: see pages 10-11

Before use

Assemble the handle using the pin provided.
When the jack leaves the factory the vent plug on the oil chamber is closed to prevent leakage. Before first using you
should remove the cover plate, unscrew the vent plug. If there is any evidence of oil leakage or shortage check the oil
level before pumping (see below). With the release valve open pump the handle six times to ensure complete distribution
of oil.
Close the release valve and the jack is ready for use.
Operation
1. Prior to operating the jack, remove any accumulated air from the system as follows:
- (1) Insert the handle into the socket and fix it with the screw provided.
- (2) Pull the handle and turn it clockwise and whilst held in this position, pump the jack several times to ensure
internal lubrication and bleed the accumulated air from the system.
- Release the handle and it will automatically return back to the initial position (dead man principle). The jack is now
ready to be used.
Important: prior to lifting the load, ensure that all of the aforementioned safety instructions are followed.
2. The wheel of the jacks should always rotated freely.
3. These jacks are fitted with a foot pedal that gives a faster approach to the load.
4. For lifting, move the handle up and down using the full stroke range of the piston for greater speed (2).
5. Secure the lifted load as an essential safety measure with an appropriate axle stand (3).
6. Before lowering, lift the vehicle to remove the axle stands, ensuring that there are no persons or obstacles under the
vehicle to be lowered. Pull the handle and turn it clockwise (4).
7. Our jacks are fitted with 2 safety device LCS that functions automatically and offers smooth and uniform lowering.
8. Once the vehicle has been lowered release the handle and it will automatically return to the initial position.
6
®
CAT2TLL
T 2
mm 75
mm 510
mm 435
kg 42
CAT25TL
2,5
85
455
368
36
CAT2TLL - CAT25TL - v1.1 - 02012014
EN