Empire GWT-25 SG Manual Del Usario

INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION
Register outlet must be cut in wall before furnace is installed.
On installed furnace, remove furnace in order to cut hole in wall
for register outlet.
1. Cut hole in the rear wall 8 1/4" (210mm) high by 11 1/2"
(292mm) wide. The lower edge of the hole is to be 45"
(114mm) above the floor plate as shown in drawing.
There are two knock-outs on the inner casing of the furnace.
2. Remove outer knock-out (4 5/8" x 9 1/2") (117mm x 241mm)
from the inner casing.
3. Remove inner knock-out (4 5/8" x 9 1/2") (117mm x 241mm)
from the inner casing.
4. Install header plate assembly and furnace according to Instal-
lation Instructions and Owner's Manual.
The rear register kit is to be attached to the furnace from within
room that is to be heated by the rear register.
5. Insert 5" x 9 1/2" (127mm x 241mm) boot through hole in the
wall and align six clearance holes on the boot with the six screw
holes on outer shield. Attach the boot to the outer shield with
(6) No. 10 x 1/2" (13mm) screws provided.
6. Insert register assembly within boot and secure register assem-
bly to wall with (2) No. 10 x 1" (25mm) screws provided.
R-3013
4/97
REAR REGISTER INSTRUCTIONS
GWTR-1 REAR REGISTER KIT
Effective Date April, 1997
Empire Comfort Systems Inc. • Nine Eighteen Freeburg Ave. • Belleville, Illinois 62222-0529
R-3013
Use pull chain to adjust damper in order to regulate heat dis-
charge.
7. If installed, remove outer casing from furnace.
8. Attach privacy shield to the front of the inner casing, approxi-
mately 12 7/8" below the top of the inner casing, with (4) #10
x 1/2" (13mm) screws provided.
9. Installation of rear register is completed.
Index Part
No. Number
1
2
3
Not Shown
Not Shown
For Model Numbers
GWT-25 (SG, RB)
GWT-35 (SG, RB)
Description
GWT-109 Register Boot
GWT-110 Register with Damper
GWT-111 Privacy Shield
GWT-112 Hardware Package
R-3013 Instruction Sheet