Using An Usb Device; Setting The Clock - LG FA164 Manual Del Usuario

FA164-CLARION_ENG 9/21/09 1:03 PM

Using an USB device

You can enjoy media files saved on a USB device by connecting the
USB device to the USB port of the unit. If you want to operate other
function, see the "Listening to CDs" section.
1 Open the USB port cover.
2 Connect the USB device to
the USB port of the unit.
3 Select the USB function.
4 Select a file you want to play.
5 Start your media playing.
6 To stop, press
7 Before disconnecting, you have
to change to any other function.
Compatible USB Devices
• MP3 Player : Flash type MP3 player.
• USB Flash Drive : Devices that support USB2.0 or USB1.1.
• The USB function of this unit does not support all USB devices.
• Devices which require additional program installation when you have
connected it to a computer, are not supported.
Look out for the follows
• Do not extract the USB device while in operation.
• For a large capacity USB, it may take longer than a few minute to be searched
• To prevent data loss, back up all data.
• If you use a USB extension cable or USB hub, the USB device is not
recognized.
• Using NTFS file system is not supported. (Only FAT(16/32) file system is
supported.)
• This unit is not supported when the total number of files is 1000 or more.
• External HDD, Card readers, Locked devices, or hard type USB devices are
not supported.
• USB port of the unit cannot be connected to PC.
• The unit can not be used as a storage device.
Page 9

Setting the Clock

1 Turn the power on
2 Press for at least 2 seconds
ON REMOTE
ON UNIT
3 Choose from either
- -
- -
4 Confirm your selection
FUNC. FUNCTION
5 Select the hours
] ] I I I I / i i i i ] ] ./>
6 Press
B B / / X X B B / / X X
7 Select the minutes
x x x x ENTER
8 Press
FUNC. FUNCTION
Using your player as an alarm clock
1 Press and hold TIMER Each function, EX) TUNER, CD.... flashes.
2 Press SET when the function you want to be woken by is showing.
3 Choose one of them by pressing SET.
4 "ON TIME" will be displayed. Then you can set the time you want the alarm to
go on. Press ] ] I I I I / i i i i ] ] to change the hours and minutes and SET to save.
5 "OFF TIME" will be displayed. Then, you can set the time you want the
function to stop. Press ] ] I I I I / i i i i ] ] to change the hours and minutes and
press SET to save.
6 You will be shown the volume (VOL) you want to be woken by.
Use ] ] I I I I / i i i i ] ] to change the volume and SET to save. Switch the system
off. The clock icon "
7 When the system is turned off, you can check the time the alarm is set for by
pressing TIMER. You can also turn the alarm on and off by pressing TIMER.
Setting the asleep time
1 Press SLEEP repeatedly to select delay time between 10 and 180 minutes,
after the unit will be turned off.
2 To check the remaining time, press SLEEP.
3 Press SLEEP once while "SLEEP 10" is displayed, to deactivate sleep
function.
AM 12:00 (for an AM and PM display) or
0:00 (for a 24 hour display)
"shows that the alarm is set.
ON UNIT
1 1 /] ]
CLOCK
] ] I I I I / i i i i ] ]
SET
] ] I I I I / i i i i ] ]
SET
] ] I I I I / i i i i ] ]
SET
9