Maintenance Free Battery - BEAL NPBR155/84H Manual De Usuario

Assembly
Mount the Grass Bag
1. Mount the grass bag assembly onto the rear
bagger brackets as shown (see Figure 5).
a. Use one hand to grab onto the handle at the
rear of the bag frame assembly.
b. Use the other hand to hold the top bagger
handle and guide the bag frame assembly
onto the rear bagger brackets.
2. When mounting the bagger frame assembly, hold
the bottom of the grass bagger assembly slightly
away from the rear plate.
3. Rotate the grass bagger assembly until it locks
in place.
4. If the bagger frame assembly fails to lock in place, adjust
the two latches (see Figure 6).
5. Remove the side and bottom trim pieces of grass bag
from bagger frame.
6. Loosen the two screws and adjust the latch until it
contacts the bagger frame assembly.
7. Tighten the screws and check that the bagger frame
assembly will lock when closed.
8. Reinstall the side and bottom trim pieces of grass bag to
bottom tube.
9. If the bagger frame assembly will not stay locked, see an
authorized dealer.

Maintenance Free Battery

IMPORTANT: Before you attach the battery cables to
the battery, check the battery date. The battery date
tells if the battery must be charged.
1. Raise the seat support (see Figure 2).
2. Remove two screws (1) and battery cover (2)
(see Figure 7).
3. Check the side of the battery (3) for the location of
the battery date.
a. If the battery is put into service before this
date, the battery cables can be attached
without charging the battery. See "Install the
Battery Cables."
b. If the battery is put into service after this date,
the battery must be charged. See "Charge
the Battery."
CHARGE THE BATTERY
WARNING
When you charge the battery, do not smoke.
Keep the battery away from any sparks. The
fumes from the battery acid can cause an
explosion.
1. Before you charge the battery (3), remove the
battery (see Figure 7).
2. To charge the battery, use a 12 volt battery charger.
Charge at a rate of 6 amps for 1 hour. If you do not
have a battery charger, have an authorized dealer
charge the battery.
3. Install the battery.
4. Connect the red cable (6) to the positive (+)
terminal using the fasteners (7). Place the terminal
boot (5) onto the positive terminal.
WARNING
To prevent sparks, fasten the red cable to the
positive (+) terminal before you connect the
negative (-) black cable.
5. Connect the black cable (8) to the negative (-)
terminal with the fasteners (7).
6. Connect the battery retainer (4).
7. Install the battery cover (2) using two screws (1).
INSTALL THE BATTERY CABLES
WARNING
To prevent sparks, fasten the red cable to the
positive (+) terminal before you connect the
negative (-) black cable.
1. Remove the protective caps from the battery
terminals (see Figure 7).
2. Slide the terminal boot (5) onto the red cable (6).
3. Connect the red cable to the positive (+) terminal
with the fasteners (7). Place the terminal boot (5)
onto the positive terminal.
4. Connect the black cable (8) to the negative (-)
terminal with the fasteners (7).
5. Install the battery cover (2) with the two screws (1).
en en
15