Klarstein 10030085 Manual De Instrucciones página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Blade Assembly Removal
• IMPORTANT: Do not remove blade assembly unless absolutely necessary!
• To removal the blade assembly, rotate the Jar collar carefully counter-clockwise as shown in the following
figure.
• Carefully removal the blade assembly by placing a thick cloth over the blade assembly and pulling straight out.
• Hint: place jar on a flat surface to facilitate removal.
• Use caution when handling the blades, they are very sharp.
• The way to removal the smoothie cup same like this.
Blade Assembly Replaycement
• When inserting the sealing and the blade assembly into the jar bottom, align the flat sides of the blade
assembly with the flat sides of the jar opening.
• Insert the Jar collar first , then hand tighten and turn clockwise until tight.
• The way to replace the smoothie cup same like this.
• Note : if the blade assembly is not tight enough , you will notice increased.
Blade Assembly Cleaning
• Wash on the blade assembly up surface in soapy water . Do not soak or use abrasive
cleaners. If necessary, scrub lightly with a soft bristle brush to removal any residue
left on the blades or nut.
• Rinse the blade assembly up surface under running water. Dry thoroughly with a
clean cloth (do not wash the bottom in water or any other liquid). Do not place the
blade assembly in the dishwasher.
12

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

10030086

Tabla de contenido