Important User Information - Peltor FMT160 Manual Del Usuario

EN

IMPORTANT USER INFORMATION

Installing and using your Peltor MC Intercom
1. Installing the microphone:
Install the mike in the helmet so that it is positioned in front of the mouth.
Install a plastic protector on the back of the mike to block wind noise.
2. Using the microphone:
The microphone is an ambient noise-compensated lip mike. When adjusting
the height of the mike (three positions on the MT63), make sure to position it
very close to or in direct contact with the mouth, 2–5 mm, for the best noise
attenuation, audibility and voice control. If the mike is positioned just 1 cm from
the mouth, the voice volume drops by 6 dB ( = by half).
3. Using the amplifier:
The amplifier is intended for permanent mounting on the motorcycle, either with
screws or cable ties. Mount the amplifier in such a way as to protect it from
moisture as much as possible. Place the wires so that they cannot snag on
anything. Test the system on site before mounting. Do not store the intercom in
temperatures exceeding 55 °C, for example on a dashboard or windowsill.
Note: Certain chemical substances may be harmful to this product. Contact the
manufacturer for more information.
For the system to work properly it must be:
1. Correctly installed
2. At the right distance from the mouth