Cord Management - Fellowes Lotus DX Sit-Stand Workstation Manual De Instrucciones

CORD MANAGEMENT

Ensure the workstation is at the highest position. Follow all cord routing instructions to ensure cables are not pinched by the support bars. Make sure
the cables are long enough to accommodate the full range of motion (17"/432mm).
STEP 1
Setup the charging stations by connecting the power cord to the power supply and the power supply to the rear USB hub port 2. Plug the power cord
into the nearest outlet. In order to use USB ports 3 and 4 for your mouse and keyboard, you will need to plug the provided Type B/USB cord into port
1 and the USB end into your computer, docking station or monitor*.
*Monitor needs to be connected to computer via additional Type B/USB cord (not included).
STEP 2A
Route the keyboard and mouse cords through the opening in the keyboard platform. Be sure to anchor the cords with the clip on the underside of the
platform. Failure to follow these instructions may result in equipment damage or personal injury.
STEP 2B
Continue routing the cords around the workstation through the cord channel to the rear. Insert the cord funnel in 1 of 2 locations on the cord channel.
Choose the location that will best accommodate your setup.
4
LotusDX_SitStand_872352_RevE_3L_053018.indd 4-5
STEP 2C
The rear USB ports are meant for data transfer devices. Plug your mouse
and keyboard into the rear USB hub and route the remaining cords
through the cord funnel.
STEP 3
Gather all cords, including the monitor cords. Apply the cable zip using the provided tool.
Push the Cable Zip upward
into the Cable Zip Tool.
STEP 4
Slide the end of the cable zip into the cord funnel to lock into place.
TENSION ADJUSTMENT
Patent pending Smooth Lift Technology™ makes it effortless to raise and lower your sit-stand. Place items onto the workstation and raise up to the
highest position. Lotus is shipped at the lowest setting which will help offset 10lbs/4.5kg. Turn the knob clockwise to offset heavier weights, up to 29
full rotations to offset 35lbs/15.8kg. As a guideline, approximately 10 full rotations are needed to offset a dual monitor setup. The exact number of
rotations depends on your personal comfort. Once you have properly adjusted the Lotus, it should feel effortless to raise and lower.
Pull down on the Cable Zip tool while
holding the top of the Cable Zip.
6/1/18 12:38 PM
5