Descargar Imprimir esta página

golmar T-540 Uno SE Guía Rápida página 3

Ocultar thumbs Ver también para T-540 Uno SE:

Publicidad

Idiomas disponibles

Idiomas disponibles

PROGRAMMING
Locate the SW2 DIP switch situated on the top left-hand side of the back
of the EL632/PLUS P/T module and set number 2 to ON. The door
panel will reproduce a sound to advise that the system has entered into
programming mode.
In systems with more than one door panel, only perform this procedure on
the main door panel of each building.
To programme the telephone with a coded door panel or from a general
door panel, see the manual of the corresponding door panel.
With the door release button pressed, lift the handset of the telephone.
To show that the system is ready for programming, the door panel and
handset will emit a number of tones, enabling the door release button to be
released.
The telephone is in audio communication
Press the button of the door panel that will call this telephone.
At this moment, the door panel and handset will emit a number of tones.
With the handset off the hook:
To programme the telephone as
Master
, replace the handset.
To programme it as
Slave
, press the door release button and then
replace the handset.
Make a call to check that the telephone has been successfully
programmed. Programme the other telephones in the same way.
Once the programming has finished, set the programming switch to OFF.
If this is not done, the door panel will emit tones to indicate that the
system is still in programming mode.
Each apartment must only have one master unit; if there are parallel
units, either monitors or telephones, they must be configured as slaves.
VERY IMPORTANT
-The T540 Uno SE telephone is fully compatible with Tekna Plus/Tekna
Plus SE monitors and T540 Uno, T-540 Plus/T540 Plus SE telephones.
It is, however, necessary to configure the door panel's SW1 DIP
switch with an Uno communications resistor (see the T632 Plus
P/T
user manual, p.
85 "
, code 50122328 ).
"
-If the distance between the door panel and the last monitor or telephone
is greater than 200 metres, or the building has more than 200 monitors
or telephones, an
RD-Plus/UnoSE
digital repeater must be used.
4
with the door panel
.
M
P
rogramming the telephone with a button door
panel.
S
5
T-540 Uno SE Telephone
Uno Digital System
QUICK GUIDE
GOLMAR S.A.
C/ Silici, 13
08940- Cornellá de Llobregat
SPAIN
Golmar se reserva el derecho a cualquier modificación sin previo aviso.
Golmar se réserve le droit de toute modification sans préavis .
Golmar reserves the right to make any modifications without prior notice.
Code 50122257 T-540
golmar@golmar.es
Sistemas de comunicación S.A.
UNO
SE EN
GR REV.0318
www.golmar.es

Publicidad

loading

Este manual también es adecuado para:

11705540a