Machine Information; Technical Specifications - VONROC LB501AC Traducción Del Manual Original

• Use only genuine replacement parts and acces-
sories.
Immediately switch off the machine when:
• Excessive sparking of the carbon brushes and
clutter in the collector.
• Interruption of the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate label.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable
for the power rating of the machine with a
minimum thickness of 1.5 mm2. If you use an
extension cable reel, always fully unroll the
cable.

2. MACHINE INFORMATION

Intended use
The leaf blowers are developed to remove leaves
from the street, garden and lawn. A fan inside the
leaf blower causes a flow of air, which can be used
to blow leaves away or to vacuum the leaves into
the collection bag.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Input power
No load speed
Max. blower velocity
Max air volume
Shredding ratio
Blower bag capacity
Weight
Sound pressure level (Lpa)
Acoustic power level (Lwa)
Vibration
WWW.VONROC.COM
LB501AC
230-240V 50Hz
3000 W
14000 rpm
270 km/h
13.2 m³/min
10:1
35 L
3.0 kg
84.1dB(A), K=3dB(A)
95.8dB(A), K=2.21 dB(A)
7.490m/s , k=1.5m/s
2 2
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-3.
1. Main handle
2. Auxiliary handle
3. Power cord
4. Cable hook
5. On/off switch
6. Upper tube
7. Lower tube
8. Vacuum bag
9. Vacuum bag inlet tube
10. Leaf bag securing clip
11. Blow/vacuum option lever
12. Carrying belt hook
13. Wheel holder
14. Wheels
15. Carrying belt
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Assembling the tubes (Fig. A, B)
• Screw the upper tube (6) onto the motor hou-
sing.
• Screw the lower tube section (7) onto the upper
tube (6).
• Mount the included wheel holder (13) by sliding
it onto the lower tube section (7) until the
EN
7