Indicator Lights; Important Safety Instructions - Fellowes POWERSHRED 2127S Guia De Inicio Rapido

A A .
B .
C.
D.
E.
F.

INDICATOR LIGHTS

Stops automatically
Stops automatically
when bin is full.
when door is
Empty bag when
opened. Symbols
bag full indicator
flash alternately
lights up
CAPABILITIES
Will shred: Paper, credit cards, CD/DVD (2127C and 2127S), staples,
paper clips and junk mail (2127C and 2127S)
Will not shred: Adhesive labels, transparencies, newspaper, cardboard,
laminates, file folders, X-rays or plastic other than noted above
Paper shred size:
Strip-Cut .........................................................................3/16 in. (4mm)
Cross-Cut ........................................3/16 in. x 1-1/2 in. (4mm x 40mm)
Micro-Cut ..........................................3/32 in. x 5/8 in. (2mm x 15mm)
* In order to perform at capacity, shredder must be plugged into a dedicated
15Amp, 120V outlet and oiled every 15-30 minutes of continuous use
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Keep hands away from
paper entry. Always set to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair,
etc. – away from shredder openings. If object enters top
opening, switch to Reverse (R) to back out object.
• Never use aerosol products, petroleum based lubricants or
other flammable products on or near shredder. Do not use
canned air on shredder.
• Do not use if damaged or defective. Do not disassemble
shredder. Do not place near or over heat source or water.
• Operation, maintenance, and service requirements
are covered in the instruction manual. Read the entire
instruction manual before operating shredders.
2
G.
H.
KEY
A. Safety Flap
B. Paper entry
C. Disconnect switch (open door)
D. Door
E. Wire Frame - paper (inside)
F. Casters
G. See safety instructions
Stops automatically Stops automatically
if too much if safety flap is
paper is inserted. opened. Symbols
Automatic reverse flash alternately
if paper jams
.
H. Control Panel and LEDs
R 2. Reverse
Overload protection.
Machine stops to cool
down- approx. 10-15
minutes. Symbols
flash alternately
Maximum:
Paper entry width ...........................................................10.25"/260mm
* 8.5"x11", 20lb., (75g) paper at 120V, 60 Hz, 5.6Amps; heavier paper,
humidity or other than rated voltage may reduce capacity.
• This shredder has a Disconnect Power Switch (C) in the door. The door
must be closed to operate shredder. In case of emergency, open door.
This action will stop shredder immediately.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or
socket of the voltage and amperage designated on the label. The
grounded outlet or socket must be installed near the equipment and
easily accessible. Energy converters, transformers, or extension cords
should not be used with this product.
• Do not operate the machine without the safety flap closed (A).
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or
batteries.
• For indoor use only.
ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ISH ENGLI H H H H SH SH SH ENGLISH ENGLISH ENGLISH NGLISH NGLISH NGLISH NGLISH GLISH GLISH GLISH GLISH LISH LISH
Models 2127S/2127C/2127M 27C/2127M
1. ON/OFF
3. Bin full
4. Door open
5. Safety Flap Open