koban KEH10-300 Manual Del Usuario página 29

KEH10-300
Hand Ratchet Crimping Tool
(2 ) Eliminate breakdown Q & A：
1. Q：How to add oil in the inside of tool when the oil is not full enough?
A：What was the cause of shortage of oil inside?
<1> It causes the oil evaporated by using for a long period.
<2> It causes leak oil by improper uses or moving.
Condition <2>: Please return the tool to supplier.
Condition <1>: Please follow below steps (Figure 5, Figure 6, and Figure 7)
for adding oil.
Figure 5. Dismantle the
fixed handle
Finish adding oil, please reassemble the parts in sequence.
2. Q：The die cannot be positioned while pressing.
A：The causes are:
<1> Shortage of Oil
<2> Air inside
<3> Impurities inside the reservoir
<4> Impurities inside the tool
Figure 6.Pull the plug
Please add oil in the reservoir up to full.
Please add oil in the reservoir up to full.
7
Exchange new Hydraulic oil.
Take apart the inner parts and clean
Figure 7. Add oil
www.grupotemper.com