Fuse Replacement; Mounting Diagram - Chauvet DJ HURRICANE 1800 FLEX Guía De Referencia Rápida

Ocultar thumbs Ver también para HURRICANE 1800 FLEX:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 5
AC Power
This product has a fixed voltage power supply and it can work with an input voltage of either 120 VAC, 60 Hz or 230 VAC,
50 Hz, depending on the specific model.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.

Fuse Replacement

1.
Disconnect the product from power.
2.
Using a flat-head screwdriver, unscrew the fuse holder and pull straight out.
3.
Remove the blown fuse from the holder and replace with a fuse of the exact same type and rating.
4.
Re-insert the fuse holder and reconnect power.
Mounting
Before mounting this product, read the

Mounting Diagram

Mounting Clamp
(such as CLP-10 from
Chauvet)
Mounting Bracket
Nozzle Adjustment
Knob (x2)
Feet for Floor
Mounting (x8)
The fluid tank of this product may NOT be tilted. The fluid tank should be level when on a surface or
when mounted.
While operating the Hurricane 1800 Flex, make sure there is adequate fog fluid in the machine to
prevent pump and heater damage. When the fog fluid level becomes low, simply add more fog fluid to
continue using the Hurricane 1800 Flex.
FCQ (Fog Cleaner Quart) was specifically developed by Chauvet to clean your Hurricane 1800 Flex.
Make sure you use FCQ regularly, no longer than 90 days between cleanings, to increase the life of
your product.
Hurricane 1800 Flex QRG Rev. 1
QUICK REFERENCE GUIDE
Safety
Notes.
EN
Safety Cable
(such as CH-05 from
Chauvet)
Carry Handle (x2)
Bracket Adjustment
Knob (x2)
2

Publicidad

Tabla de contenido
loading

Tabla de contenido