Rigging Instructions; Rigging Cable - Work Pro W SoundNut Serie Manual Del Usuario

Ocultar thumbs Ver también para SoundNut Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SN6
USER MANUAL
VERSION 1.0

6. RIGGING INSTRUCTIONS

SN6 uses a quick and simple solution that allows its installation in a wide variety of facilities, using a
keyless release mechanism.
To install the SN6 correctly, two CS 10 E cables must be used, one as main rigging cable, and one as
safety cable. The cables are included in the SN6 system.
CS 10 E is a 5m long with a Gripple® loop end fixing, steel cable. The cable also includes an additional
Gripple® locking device to ensure the rigging position.
Quick adjustment, CS 10 E does not require tools for adjustment.

Rigging cable

Pass the loop end over
the building feature.
Adjust the desired height
by pressing the button
and sliding the locking
device at the same time.
SN6
+
Thread the tail wire
through the loop to
create a choke knot.
Pass the tip of the wire
through the central hole of
the hanging point of SN6.
www.workpro.es
Pass the tip of the wire
through a hole in the
Gripple® locking device.
Pass the tip of the wire
through the free hole in the
Gripple® locking device.
Ensure a minimum 75mm
of tail wire exit the hanger.
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sn6

Tabla de contenido