Danfoss EKE 1P Manual Del Usario página 4

LED B: Two status LEDs to indicate valve operation
V1. Valve closed
V2. Valve closing
V3. Valve idle
V4. Valve opening
V5. Valve open
= Red
R
= Green
G
Commonly used parameter identification in application 2:
Note: In application 1, the most commonly used parameters are configured in the AK-PC. Default commissioning password: "300"
Parameter Default
Main switch
Mode
AI valve input scale
Valve configuration
4 | AN31542506734401-000301
0s
0s
R R R R
0s
0s
G G G
0s
Description
0 0 = Off, 1 = ON
0 0=Application 1 - selection by AI4
1=Application 1 - High Pressure expansion module
2=Application 1 - Receiver Expansion module
3=Application 2 - Valve Driver
Note: changing this setting also changes the EKE 1P address, causing communication with the graphical
display to stop. Communication will resume after a power cycle.
2 0 = 0 – 5 V
1 = 1 – 5 V
2 = 0 – 10 V
3 = 2 – 10 V
4 = 5 – 0 V
5 = 5 – 1 V
6 =10 – 0 V
7 =10 – 2 V
8 = User Defined
0 Application mode 1: Set from AK-PC except if the valve type is set to User Defined in AK-PC then it is
according to below list (see Application mode 2)
Application mode 2:
0 = no valve, 1 = UserDef
2 = ETS 12C, 3 = ETS 24C, 4 = ETS 25C, 5 = ETS 50C, 6 = ETS 100C
7 = ETS 6, 8 = ETS 12.5, 9 = ETS 25, 10 = ETS 50, 11 = ETS 100
12 = ETS 250, 13 = ETS 400
14 = KVS 2C, 15 = KVS 3C, 16 = KVS 5C
17 = KVS 15, 18 = KVS 42
19 = CCMT 0, 20 = CCMT 1
21 = CCMT 2, 22 = CCMT 4, 23 = CCMT 8, 24 = CCMT 16, 25 = CCMT 24
26 = CCMT 30, 27 = CCMT 42
28 = CCM 10, 29 = CCM 20, 30 = CCM 30, 31 = CCM 40
32 = CTR 20
33 = CCMT 3L, 34 = CCMT 5L, 35 = CCMT 8L
1s 2s
R
1s 2s
R R R R
1s 2s
1s 2s
G G G G G
1s 2s
G
Steady red = valve fully closed.
Flashing red (2 Hz) = valve closing.
Running on target.
Both Red and Green off.
Flashing green (2 Hz) = valve opening.
Steady green = valve fully open.
© Danfoss | DCS (vt) | 2020.03