Hotronic Snapdry Manual Del Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
Snapdry Boot & Glove Dryer 120V/230V contains:
• 1 Blower Assembly 120V/230V
• 1 Power Cord with 120V or 230V plug
• 1 Air Manifold Assembly (Upper Deflector, Wire Form
Clip, Flexible Tubing, Integrated Hand Wear Stand)
• 1 Accessory Kit (2 Right Angle Extensions, 2 Straight
Extensions)
• 1 Nylon Storage Bag
USING BOOT & GLOVE DRYER
1. NOTE: DO NOT ALLOW BLOCKED AIRFLOW.
BLOCKED AIRFLOW MAY CAUSE DAMAGE TO
DRYER AND MAY INCREASE DRYING TIMES
SIGNIFICANTLY.
2. Insert Blower Assembly into Upper Deflector of Air
Manifold Assembly (see drawings).
3. Attach Right Angle Extensions or Straight Extensions
to bottom ends of Flexible Tubes.
4. Use Right Angle Extensions for tall footwear.
• CRITICAL: With footwear together, place single
Tube in each boot and push Dryer down to
position where Right Angle Extensions are just
above floor of boot and pointed toward toe area.
This properly directs warm airflow. Do NOT allow
blocked airflow.
• EXTRA: Tall, high boots require adjusting overall
length of Flexible Tubes and Right Angle
Extensions as long as possible to properly direct
warm airflow into toe area. Do NOT allow blocked
airflow.
• NOTE: Right Angle Extensions have left hand
threads. Always turn clockwise to loosen and
counter-clockwise to tighten.
5. Use Straight Extensions for gloves, mittens, and low
cut footwear.
• CRITICAL: Make certain to use Straight
Extensions when drying gloves, mittens, or low cut
footwear to properly direct airflow. Do NOT allow
blocked airflow.
• LOW CUT FOOTWEAR: With footwear together,
place single Tube in each shoe and push Dryer
into position until Straight Extensions are inserted
all the way into toe area. Do NOT use Right Angle
Extensions in low cut footwear as airflow will be
blocked. Do NOT allow blocked airflow.
• GLOVES AND MITTENS: Position Dryer with
integrated Hand Wear Stand resting on surface
and Flexible Tubes pointing upward. Pull each
glove or mitten over single Tube until Straight
Extensions are inserted into finger area of mittens
CONTENTS
1

Publicidad

Tabla de contenido
loading

Tabla de contenido