General Operation - Hotronic Snapdry Manual Del Usuario

or upper palm area of gloves (or glove lined
mittens). Do NOT insert Straight Extensions into
single finger or thumb area of gloves (or mittens)
as airflow will be blocked. Do NOT allow blocked
airflow.
• NOTE: Straight Extensions may be pushed onto
and pulled off of Flexible Tubes. Also, Straight
Extensions have left hand threads. Always turn
clockwise to loosen and counter-clockwise to
tighten.
6. Before operating Dryer, first remove all excess snow,
water, and other moisture that may have
accumulated in boot, shoes, gloves, or mittens.
1. Before plugging Dryer into wall outlet, determine
electrical current being used.
• If current is 120V, set Voltage Selector Switch to
120V (see drawing) and use proper Power Cord
with 120V plug on end. Plug other end of Power
Cord into Blower Assembly.
• If current is 230V, set Voltage Selector Switch to
230V (see drawing) and use proper Power Cord
with 230V plug on end. Plug other end of Power
Cord into Blower Assembly.
2. Once proper voltage and Power Cord plug end are
selected, plug Dryer into wall outlet.
3. Using Dial on Built-In Timer, set desired approximate
drying time (see drawing).
• Built-In Timer is electronic. Dial setting remains at
selected drying time and does not change position
according to elapsed time.
• Maximum drying time before automatic shut-off is
approximately 24 hours.
• Minimum drying time before automatic shut-off is
approximately 1 hour.
4. Once desired approximate drying time is set, push
Power Button to turn Dryer on (see drawing).
• Dryer will automatically shut-off per Dial setting.
5. To shut off Dryer before automatic shut-off, push
Power Button.
• NOTE: Pushing Power Button to shut off Dryer also
resets Built-In Timer.
• NOTE: When Dryer is on, Dial setting may be
adjusted to longer or shorter drying time. Dryer will
automatically shut-off according to new Dial setting.
When adjusting Dial to drying time shorter than
elapsed time, Dryer will automatically shut-off within
1 hour.
PRE-WARMING HAND & FOOTWEAR
1. With boots, shoes, gloves, or mittens already dried,
use same procedures as above to pre-warm hand or
footwear.
2. To pre-warm to approximately body temperature
2

GENERAL OPERATION