Porter & Cable FR350A Manual De Instrucciones página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.
Depress nail follower (E) and slide fasteners from magazine.
Fig. 12
H
4.
If nail is jammed between the driver and nose casting force driver blade back to the
top using a 1/4" (6.4 mm) punch and hammer. When the nail is released it will fall
free or can be removed using pliers.
Fig. 13
5.
If nail still can not be removed, remove the magazine:
a.
Remove screws (N).
b.
Remove magazine.
c.
Remove bent nail.
d.
Reassemble in reverse order.
note: Should nails continue to jam frequently in nosepiece, have tool serviced by an
authorized PORTER-CABLE service center.
COLD WEAThER OPERATION
When operating tools at temperatures below freezing:
1.
Make sure compressor tanks have been properly drained prior to use.
2.
Keep tool as warm as possible prior to use.
3.
Make certain all fasteners have been removed from magazine.
4.
Put 5 to 7 drops of PORTER-CABLE pneumatic tool oil in the air inlet.
5.
Lower air pressure to 80 psi or less.
6.
Reconnect air and load nails into magazine.
7.
Actuate the tool 5 or 6 times into scrap lumber to lubricate O-rings.
8.
Turn pressure up to operating level (not to exceed 120 psi) and use tool as normal.
9.
Re-lubricate at least once daily.
10. Always drain the compressor tanks at least once a day.
hOT WEAThER OPERATION
Tool should operate normally. However, keep tool out of direct sunlight as excessive
heat can deteriorate bumpers, O-rings and other rubber parts resulting in increased
maintenance.
I
12 - ENG
e
Fig. 14
n

Publicidad

Tabla de contenido
loading

Productos relacionados para Porter & Cable FR350A

Tabla de contenido