Tools Required - Forest-Master ULTIMATE Manual Del Usuario

STEP 1:
Connect the left upright (1)
and 2 v-blades (2) using
an M12 x 125 mm bolt (4)
and M12 nyloc nut (3). Note
that if the left upright is laid
flat with the two vertically
aligned holes to the left, as
shown in the diagram then it
has a longer ferrule project-
ing to the right.
longer
TOOLS REQUIRED: Spanners: 10 mm, 13 mm, 17 mm, 19 mm
NOTE: Do not fully tighten nuts and bolts until after the
assembly is completed.
Ultimate Sawhorse
longer
Allen keys: 5 mm, 6 mm, 8 mm, 10 mm
longer
STEP 2:
Connect the right upright (5)
and the remaining 2 v-blades
(2) using the remaining M12 x
125 mm bolt (4) and M12 nyloc
nut (3). Note that if laid flat
with the two vertically aligned
holes to the left as shown, the
right upright has the longer
ferrule projecting to the left.
longer
5