CANDY HOOVER LARDER Manual Del Usuario página 19

o Remove the grid on the base of the appliance by unscrewing the screws on
each side of the grid and then pull the grid towards you.
o Use a spanner to adjust the height of the adjustable feet.
o If your aperture has a height of 820 mm, then the adjustable feet should be
fully tightened.
o If your aperture has a height of 870 mm, then the adjustable feet should be
set at a height of 50 mm.
o The appliance should be flush with the underside of the worktop and be
level.
IMPORTANT: If the appliance is not level, then the door and door seal may
be affected.
o A cut out must be made in the plinth/kickboard for ventilation. The cut out
should measure 600mm in width, and between 140mm and 90mm in height,
depending on the height that you have set your appliance.
o Insert the plinth/kickboard and then refit the grid in its original position to
hold it in place.
IMPORTANT: Please note that as shown in the above drawing, an
appropriately sized ventilation cut out MUST be made in the furniture
plinth/kickboard.
Fitting the furniture door to the appliance
If you need the appliance door to open from the other side, then please
reverse the door before commencing the installation process. (See "Reversing
the door section").
Tools required:
o Tape measure
o Sharp pencil
o Small flat bladed screwdriver
o Spanner
IMPORTANT: We recommend that two people install this appliance.
1. Undo the screws from the two adjusting bolts that are located on the top of
the appliance door and then remove the mounting bracket (1).
2. Measure the width of the furniture door, at the halfway point mark a line
vertically down the inner surface of the furniture door. You should draw
the line from the top of the furniture door to approximately halfway down.
o Place the mounting bracket (1) on the reverse of the furniture door.
o The middle of the mounting bracket should be positioned on the line that
you have just drawn. Please note the position of the mounting bracket in the
above drawing, to ensure that you have the mounting bracket the correct way
up.
o The top of the mounting bracket should be positioned approximately 15
mm from the top of the furniture door. This will allow you a 5 mm gap from
the top of the furniture door, to the underneath of your worktop.
o Fix the mounting bracket to the furniture door using the screws provided
and a Phillips-head screwdriver. These screws should be fully tightened.
3. Hang the furniture door onto the appliance door, making sure that the
brackets on the mounting bracket locate over the adjusting bolts.
19