Clock Setting - QFX R-70S Manual De Instrucciones

INSTRUCTIONS FOR USE
Charging the product
Note: For best results, fully charge the product before its first use.
1. Connect the USB charging cord (included) to the DC 5V charging port of the
product and insert the other end into a port on your computer or similar power
source.
2. The battery indicator
(press the MF button to turn on the product, if necessary). Once it is fully
charged, the battery indicator is full and stops flashing. It will take 5 - 6 hours to
fully charge the battery.
3. Once the product is fully recharged, disconnect the USB Cable and firmly close
the Rubber Flap, to cover the USB Charging Port secure. If the USB charging port
is not securely covered, water may seep into the electronics circuit and may
damage the product. This damage will NOT be covered under product warranty.
Turn On/Off the Product
Press and hold the MF button for 2-4 seconds to turn on the product (*digital display
with backlight will on, and the backlight will turn off automatically after around 15
seconds. Press the
seconds.)
Press and hold the MF button for 2-4 seconds to turn off the product.

Clock Setting

1. After turning on the product, press the Mode button until digital display showing
'Lod'.
2. Short press the MF button, and the "hour" field on digital display will flash quickly.
3. Press the or
4. Press the MF button to confirm and the "minute" field will flash to prompt for
adjusting.
5. Press the or
6. Press the MF button again to complete the clock setting.
Pairing your device with Bluetooth Speaker
Your Bluetooth Speaker can wirelessly stream audio from any Bluetooth enabled device
within the distance of up to 26-33 Feet. Simply follow the below steps.
1. After turning on the product, press the Mode button to enter Bluetooth mode
with digital display showing 'bt', and an indication tone is heard. Your speaker is
now ON and is entering "pairing" mode.
2. Turn on the Bluetooth on your Mobile Phone or Tablet or Computer.
3. It will search for various devices.
will flash to indicate that the battery being charged
or button will also turn on the backlight again for around 15
repeatedly button to set the correct hour.
button to set the correct minute.
4