Vapir NO2 Manual Del Usuario página 2

IDENTIFYING THE PARTS
Top / Mouthpiece
Top / Mouthpiece opening
(unscrew to open)
LED Heat
indicator light
Digital Temperature
Display
Temperature
Down Button
Heat ON/OFF Button &
C/F Temperature Setting
Set/Actual
Temperature
Battery charge
indicator
Power ON / OFF
Button
Temperature
Up Button
Battery Door
1
PRE USAGE INSTRUCTIONS ADDITIONAL PARTS
The NO2 comes with 1 Internal Re-Chargeable Battery, 1 Power Cord, 3 Sets
of Mesh Bowl (1 already installed), 2 Bamboo Cleaning Sticks, 1 Measuring
Cup, 1 Cleaning Brush, 1 Tube Attachment and 1 X-Tip Mouthpiece.
Prior to using the tube attachment, make sure to soak it in warm water (DO
NOT USE BOILING WATER). It is suggested that you use the tube attachment
while vaporizing for a much better draw. To install the tube, simply push one
end of the tube over the top of the unit until it is fully secure.
You can also use the mouthpiece in conjunction with the tube. Installation of
the mouthpiece is quite easy, simply push the open end (the larger opening)
over the open end of the tube until it is fully secure.
Included are 2 sets of mesh screens for usage when the rst set becomes too
dirty or worn out. You can clean the mesh screens using the cleaning brush.
Changing Internal Mesh Screen - Using the Bamboo Cleaning
stick (included with the unit) put the stick inside of the herb
chamber and grab the bottom of the mesh screen and lifts out
- the screen should come out quite easily. To install the new
screen, use the bamboo stick and simply push the screen
inside the herb chamber until it reaches the bottom and is
ush with the bottom of the herb chamber.
Changing Mouthpiece Mesh Screen - Remove the top of the
unit by gently turning it counter-clockwise. Turning the
mouthpiece over you will see the mesh screen holder. To
remove the mesh screen simply locate the 3 lines on either side
of the mesh screen holder. Securely grab the 3 lines and turn
counter clockwise to open. If mesh screen holder is di cult to
remove you can gently use pliers to do so. Remove the old mesh
screen and insert a new mesh screen. To assist with installation
of the mouthpiece mesh screen use the tip of the NO2 (when
removed from unit) to depress the screen into the correct shape.
Now replace the mesh screen holder by pressing down and
turning clockwise until secure.
2