Run A Program (Working) - Selecta MACROTRONIC BLT Manual De Instrucciones

INSTRUCTION MANUAL
Time Speed
J
.P. SELECTA s.a.u.
CODE 80316
7.3
From the main menu, press on «WORKING».
Program selected in the former paragraph will be running.
Press on «RUN» to start the program.
The program starts and displays the following information:
- Program and rotor number.
- Current and target speed.
- Elapsed (minutes, seconds) and target time.
- Temperature in the bucket and target temperature.
Press on «RPM» so that the display shows «RCF».
RPM: Revolutions per minute.
RCF: Number of «g» (acceleration of gravity) to which the sample is
Temperature
subjected to.
The program notifies the end with a long beep.
Press "STOP" to end the program execution.
Press "OPEN" to open the lid.
Press "BACK" to return to the main screen.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
REV C

Run a program (WORKING)

05/2020 Page: 15
Tel 34 937 700 877 Fax 34 937 702 362