Installation Instructions; Notes For The Fitters; General Safety Instructions - hafele 421.68.278 Traduccion De Las Instrucciones

2. INSTALLATION INSTRUCTIONS

2.1 Notes for the fitters

2.2 General safety
instructions
NOTE
The installation instructions are intended for qualified personnel only (such as
cabinet makers, joiners, furniture manufacturers).
The following basic instructions must be applied during the installation.
Basic safety instructions:
> Do not carry the TV lift by the cable.
> Check all delivered product components for damages prior to the
installation! Never install damaged product components, but complain to
the manufacturer.
> Never modify or replace plug and cable.
> Do not omit any delivered parts. Adhere to the assembly sequence.
Do not install any parts that are not approved by the manufacturer.
> Fix the manual switch inaccessible for children. Verify that children cannot
access the control unit. Install the cables so that children
cannot be caught in these or be strangled.
Electrical safety:
> Do not install and store product components and cables near hot
surfaces, heat sources, easily flammable materials or areas with direct sun-
light.
> Never expose product components and cables to humidity and never install
or store near water, damp, aggressive or potentially explosive areas.
> An earthed shockproof socket installed according to national
regulations must be available for the electrical connection. The
connection data of the socket must match the connection data of the TV lift
(see chapter "2.3 Installation requirements / Technical data").
> Install product components so that the power cable can be connected di-
rectly to the socket. The use of output extenders or adapters is
prohibited!
> Do not jam, crush, bend or damage the cable during the installation (e.g. by
drilling, cutting). Do not place cable over sharp edges or corners. Install ca-
ble at a sufficient distance to movable or rotating parts.
> Clearly (but without any strain) tie together excessively long cables by using
cable ties or a strain relief device. The cable routing must be clearly recog-
nisable.
> Do not place cables on the floor. They could become a hazardous
tripping risk and become damaged by being walked on.
25