Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FreshStartFuelCap
Adding fuel preserver helps keepfuel fresh and carburetors
clean for easier starting, all season long. This new fuel cap
automatically drips concentrated fuel preserver into your fuel
tank_
DANGER
Contents are harmful or fatal if swallowed. Avoid
_
ontact to eyes, skin or clothing. DONOTtake
internally. Avoid breathing the mist or vapor.
Overexposureto eyes or skin can cause irritation.
Keep stabilizer out of the reach of children.
Fuel stabilizer is a hazardous chemical.**
o If SWALLOWED, callphysicianimmediately.
o In the caseof an emergency, c ontacta physician immediately
andcall 1-800-424-9300 for material s afetyinformation.
**Fuel stabilizer contains: 2,6-di-tret-butylphenol
(128-39-2) and alipbatie petroleum
distillate (64742-47-8).
1.
Placecartridge into fuel cap.
J
2.
Pushto "snap" cartridge into place.
3.
Removetab to expose membrane.
IMPORTANT:DO NOT remove the silver foil seal on the
opposite side.
4.
Reinstall fuel cap on fuel tank.
5.
Periodically check the cartridge to ensure there is still
fuel stabilizer inside. If it is empty, remove cartridge and
replace.
HighAJtitude
At higher altitudes (over 5,000 feet), 85 octane/85 AKi
(89 RON)gasoline is recommended. High-altitude use may
require a carburetor jet kit to improve performance and
decrease fuel consumption. See any Sears or qualified dealer
for more information.
Connect Hose and Water Supply to Pump
instructionwill voidwarranty.
NOTE:Removeand discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1.
Uncoil high pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
The high pressure stream of water that this
_
quipment produces can cut through skin and its
underlying tissues, leading to serious injury and
)ossible amputation.
o NEVER connecthigh pressurehoseto nozzle extension.
o Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized.
o Alwaysbe certainspraygun,nozzles and accessories are
correctlyattached.
2.
Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
Publicidad
Tabla de contenido
