Inserting Battery - Seac R3-R3FX Instrucciones

INSERTING BATTERY

• Unscrew the aluminium cap at the end of the handle, turning
counter-clockwise.
• Insert the battery, making sure that the positive pole (+) is pointing
into the torch.
• Grease the sealing O-rings with a layer of silicone grease.
• Screw the aluminium terminal at the end of the handle back on,
turning clockwise.
Failure to fully tighten the cap could result in water leaking into
the torch during use.
• Check that the torch turns on using the switch.
If the batteries are inserted incorrectly (inverted polarity), a short
circuit will be created, causing irreversible damage and a risk that
the torch could explode.
SWITCH
The R3 torch has a sliding magnetic switch with three positions: 100%
light output, low power setting (30% of maximum power), and flashing.
The R3 FX version has only the ON/OFF function.
ENGAGING OR DISENGAGING THE SAFETY
The torch features an exclusive and effective safety system, designed to
prevent the torch from switching on accidentally. To engage the safety,
rotate the round ring nut located right behind the switch. Turn it all the
way and the word "ON" on the switch will no longer be visible and the
switch will be locked. To disengage the safety, turn the ring the other
way until the word "ON" is visible on the switch. In this position the
switch is not secured and is operative.
14
867-manuale Seac torce serie R3 R3FX.indd 14

WARNING

WARNING
18/09/2018 10:00:18