SilverBack B5404W Manual Del Usario página 12

Sistema de basquetbol
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

26.
Mount goal assembly (#28) and rim pad (#27) to
backboard, as shown in
(#41), four washers (#26), and four locknuts (#4).
tighten fasteners finger tight, leave them loose
enough to level rim.
27. Place a level across rim assembly and adjust rim until
it is level. Finish tightening the four nuts.
Figure 13
41
41
NEVER USE RIM WITH COVERPLATE REMOVED!
28. Attach rim cover plate (#32) using two screws (#33). See
Figure 13.
29. Check all nuts and bolts and make sure everything is
tightened properly. DO NOT over tighten pivot points,
snug is tight enough.
30.
Use the backboard pads (#37) and (#38) as a template and
mark the hole locations on the backboard frame. See Figure
13
and
Detail A
.
Figure 13
, using four bolts
38
33
28
40
29
(Pre-Installed)
27
32
Note: Safety glasses required for Step 31.
31. Drill 9/64" pilot holes into steel backboard frame. See
Detail A. Do not drill through both sides of tube.
Note: Cordless drill recommended for screw installation.
Do not over tighten screws.
32. Secure backboard pads (#37) and (#38), as shown, using
screws (#42). Note: Tighten screws tight but, do not over
tighten.
12
26
4
42
37
42
Pad #37 & #38
Screw #42
Detalle A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

B5404f

Tabla de contenido